sellncars
New member
Hello Everyone,
I own a Dewalt rotary #849. I recently purchased a Hook & Loop backing plate and some 8" pad's from Top Of The Line for my rotary. My question is, Can i use these pad's with my Porter Cable #7424 with a 6" backing plate and 6" weight, without having any major problems?? The Hook & Loop velcro backing plate that Top Of The Line sold me was a 7 1/2 plate, The pad's on the velcro side are 7 1/2. When i place the pad's on the backing plate, the plate is real close to the outside of the pad. This is sort of scarry because it is so close. They say it is an 8" pad, Yes on the outside.. Question #2: Would i be better off getting a smaller backing plate for the rotary?? I was just wondering if i could use these pads for both units?? Thanks,
I own a Dewalt rotary #849. I recently purchased a Hook & Loop backing plate and some 8" pad's from Top Of The Line for my rotary. My question is, Can i use these pad's with my Porter Cable #7424 with a 6" backing plate and 6" weight, without having any major problems?? The Hook & Loop velcro backing plate that Top Of The Line sold me was a 7 1/2 plate, The pad's on the velcro side are 7 1/2. When i place the pad's on the backing plate, the plate is real close to the outside of the pad. This is sort of scarry because it is so close. They say it is an 8" pad, Yes on the outside.. Question #2: Would i be better off getting a smaller backing plate for the rotary?? I was just wondering if i could use these pads for both units?? Thanks,
