Waterless Washes
While they do seem to work I`m still sort of old school when it comes to these and prefer lots of water and lubricant with cleaning my vehicles.
Rinseless Washes
A couple of years ago I started using some of the new Rinseless Washes. There are several out there that work well but these two really perform well; Detailer’s Pro Series Rinseless Wash & Gloss and Optimum No Rinse. I mix these as well in hot water and use rubber gloves. I put some of the solution in a garden sprayer and soak down each panel allowing the solution to soften and begin dissolving the surface contaminates.
Next I dip a wool wash mitt in the solution then lightly wash each panel twice, once to remove the initial grime then a second time to remove any remaining and float them harmlessly to the floor. At first I was very apprehensive using these products because I was afraid of scratching the finish but it does a damn good job at protecting it.
Rinseless washes work great but I can`t wait until the finish becomes caked with winter driving salts and sands like some do. If this does become the case then it`s off to the car wash to blast away the heavy stuff with plain waster only.
Additionally,
Once the car`s dry I like giving the finish some additional protection by give the entire finish a once over with a quality spray wax and Optimums Spray Car Wax is the best I`ve found to date. BlackFire Wet Diamond Polymer Spray is another great choice and both are easy to use.. Both are a spray and wipe products that perform superbly leaving a glossy shine and 4 to 5 months of added protection...
Here`s the above step by step.
- Liberally wet down the panel and let it set
- Wash lightly using plenty of solution
- Rinse mitt and wash again allowing remaining contaminates to flow off the panel
- Dry with a Microfiber Guzzler towel while warm
- Every second wash I go over each panel with Optimum Spray Wax or BlackFire Wet Diamond Polymer Spray
BobbyG
It is pretty clear some use the words rinseless and waterless like a strait jacket that prevents just doing the right things. In a traditional soap wash there are extremes (power washing, pre-foam to just a single bucket). Despite the words rinseless and waterless, doing a hose pre-rinse is not a crime against nature.
If it in doubt, hose is down (end up using maybe 3 to 4 gallons of water more max) if you can as you would do with any wash process. I think the key is just how much you are picking up in your wash media. If after one wipe, the mf is extremely dirty, it may warrant a different process.
Al
The Need to Bead
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks