Shoot - the Original Post is from 3 years ago!!!!
Man, am I a dumbo...
Dan F
Ivandabomb -
Welcome to the Forum -
How about you get some smaller backing plates, pads, and a rotary adapter and you will be able to get that small pad anywhere and have all the power of a Rotary?
Click -
Optimum Double-Sided Rotary Adapter
Just put the cord over your shoulder and behind you while you work and it`s not in the way or touches anything...
It also helps if the extension cord and the tool cord are not all twisted up, etc., I make sure I`m careful how I wind up all the cords so they don`t get a "set," by using large loops, and they work better that way.
Lastly, when you unwind an extension cord that is really long and in large loops, you first put down on the floor, the end of it that was wound up last, and then Unroll it backwards, you walking it backward, and it will come out all straight and flat on the floor, because you did not twist it up to start...
All really good Cable Guys that cable up huge Buildings do this with all the cabling that goes into them...
Good Luck !
Dan F
Bookmarks