My Hook up

[shortd81]

$140 for a full wrap???????!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Holy cow that is cheap. i would be all over it!

that`s what I`m saying. Ranges usually $400-$1500 he said.

[shortd81]

Yes, a brush would work fine. or you can go to wal mart and get a roller and pan for less than $2. Would probably go faster.

When you are doing the floor, make sure you do not breathe alot in...take a few breaks to get fresh air...

So would it be ok if I leave the bolts and screws in and just roll over them?

[Tex Star Detail]

Yes. Are you going to put tile down too? And are you gonna do the sides with paneling?

[shortd81]

Yes. Are you going to put tile down too? And are you gonna do the sides with paneling?

Yes I`m gonna try to deck it out just don`t know how hard it will be since I`ve bolted everything down as far as getting it over the bolts

[Tex Star Detail]

I would wait for a full day and tackle it. First thing in the morning, remove everything. Then put the sides up, seal the floor and let it dry, and then lay the tile. When done, I would re-install everything. Shouldn`t take more than a day. The sides shouldn`t take more than 30 minutes, since they are alreay the right size, minus the front. Just spread liquid nail all over the back of the panel and stick. The floor seal shouldn`t take too long. Depends on how many coats.

[shortd81]

I would wait for a full day and tackle it. First thing in the morning, remove everything. Then put the sides up, seal the floor and let it dry, and then lay the tile. When done, I would re-install everything. Shouldn`t take more than a day. The sides shouldn`t take more than 30 minutes, since they are alreay the right size, minus the front. Just spread liquid nail all over the back of the panel and stick. The floor seal shouldn`t take too long. Depends on how many coats.

Ok now look at this picture if you notice how I have it bolted down. How Would I do that. Just split it and make it come together or cut a hole in the tile and lay it over it. I want it to look very nice.

[Tex Star Detail]

Is there any way you can remove the bolts? Or would that be too much of a pain?

[shortd81]

Yeah I`ll post some pics tomorrow if I finish it

[Tex Star Detail]

Sorry I did not post earlier, had errands to run.
So are you doing things right now?

[shortd81]

No I wanted to wait to hear from you.....I`m doing it 7am in the morning in hopes I don`t receive no phone calls

[Tex Star Detail]

sweet......Pics when done for sure

[2005Accord]

wow! this makes me antsy to get me a trailer. Where did you get the water tank? Am I understanding you correctly...you built that from scratch? How much do you charge for plans?

Real sweet job bud!

[shortd81]

wow! this makes me antsy to get me a trailer. Where did you get the water tank? Am I understanding you correctly...you built that from scratch? How much do you charge for plans?

Real sweet job bud!

Thanks man
I got the water tank from the Tracker Supply Company in Deland, Florida
and yeah I built it from scratch. The trailer was already put together though just had to put all equipment inside. Isn`t hard at all. I`ve been thinking about building them and then financing them. Could make some extra cash that way.

[Tex Star Detail]

Just search other threads and get ideas from other peoples` setups. It is alot cheaper to build your own setup, than to buy a pre-fab set-up.

I don`t know if I understand correctly...are you asking if he built the trailer itself from scratch? ot the setup inside?

[2005Accord]

I was wondering if the trailer itself was hand-built..ie the frame, wheels, hitch etc. That would be a good side biz too...trailer rental.