To Poorboy`s Steve

**Poorboy** · 09-15-2004, 08:18 PM

actually i would use Spray and Wipe and as little water or washing between coats for that very reason and to letthe EX-P fully cure.
after long talks with my chemist , for optimum use, he concluded that sealants should be kept dry for 72 hours after application . A small amount of Spray and Wipe will not effect the EX-P very much at all.

**jaybs02** · 09-15-2004, 08:21 PM

Most "car" washes will unless they are specially designed to

**mpower1226** · 09-15-2004, 08:23 PM

also, now that you`ve told me I cant do anything about peels by hand, What If I get my hands on the PC? will that help using it with ssr serise? for the little orange peel?

**Poorboy** · 09-15-2004, 08:30 PM

Originally posted by mpower1226
also, now that you`ve told me I cant do anything about peels by hand, What If I get my hands on the PC? will that help using it with ssr serise? for the little orange peel?

in reality you would need to wet/dry sand and use a rotary for removing orange peel. Over the long term using a product like SSR2.5 you would be able to level the surface and remove some, but probably not all:dunno

**mpower1226** · 09-18-2004, 01:57 AM

ok, after talking with steve, I placed an order for

ssr1, natty`s, PwC, EX through the Canadian distributor listed on

poorboys page.

now here comes the dumb question.

How do I use these? What is the proper way to doit by hand and do it bby PC(will be getting later).

I thought I need to put a thin layer then let it dry and take it out? is this correct way? My question is, for polisher to work, shouldnt I need to rub it on the paint surface instead of just let it dry and strip out the residue?

and same with using pc, say I put the ssr1 on the car speed set at 3. then do I wait to dry up or do I just increase the speed to 4~5 and buff the sh@it out of it? I know for wax, I just put it on and let it dry and stip out. for how do I really use the polisher or sealent or ssr.

**Poorboy** · 09-18-2004, 07:21 AM

Follow directions on the back of the bottles for best use...

By hand rub polishes(SSR1) back and forth until the virtually disappear, or start to dust. Use a clean mf cloth and wipe up residue
PwC has four choices of application on the label..pick the one that suits you...
EX apply with damp sponge applicator, let dry and wipe off
Natty`s spead over half or whole car..let haze..wipe off...

**GearHead_1** · 09-18-2004, 04:48 PM

Originally posted by The Fuzz
He did give him a break. We are going to start deleting threads that are in the wrong forum to help encourage people to post in the correct forums. THANK YOU!

This is the nice, friendly forum that we`ve all come to know and love.

**GearHead_1** · 09-18-2004, 04:49 PM

Originally posted by The Fuzz
He did give him a break. We are going to start deleting threads that are in the wrong forum to help encourage people to post in the correct forums. THANK YOU!

This is the nice, friendly board that we`ve all come to know and love.