My PB Syn1 has arrived.

**TroyScherer** · 06-26-2010, 02:55 PM

I can’t wait to try this out. I think I have lined up the perfect candidate for my test a Black Cavalier Z24.
I’ll post up my reveal as soon I can get a hold of the car. I would like to test this side by side with another polish I already have. I’m thinking of M105 or XMT 3 or 4. Would any of these be a good product comparison to use? What is the cut and finish of Syn1 comparable to?

If anyone has any suggestions let me know. Thanks

**Dtrick.22** · 06-27-2010, 07:21 AM

It cuts and finishes very quickly which I think is pretty neat. But be prepared for lots of dusting

**Poorboy** · 06-27-2010, 08:35 AM

Originally Posted by Dtrick.22

It cuts and finishes very quickly which I think is pretty neat. But be prepared for lots of dusting

yes, the dusting will be something we address in the next version

**tmacsad** · 06-27-2010, 09:48 AM

Steve, is the SYN 1 listed on your site?

**TroyScherer** · 06-27-2010, 01:43 PM

Steve,
Can you give me an idea of the cut and finish ability for Syn1? Does it cut like SSR2.5 or 3? Also what should it finish down compared to? I want to make sure I am fair in my evaluation. Thanks

**Poorboy** · 06-27-2010, 07:12 PM

Originally Posted by TroyScherer

Steve,
Can you give me an idea of the cut and finish ability for Syn1? Does it cut like SSR2.5 or 3? Also what should it finish down compared to? I want to make sure I am fair in my evaluation. Thanks

actually i could, but we need feedback and want to see what results each tester gets without pre-conceived expectations

**G.T.Subie** · 06-27-2010, 08:02 PM

Will this be available at the Detail Weekend

**tuscarora dave** · 06-27-2010, 10:31 PM

I will be detailing a Dodge Ram tomorrow with what I believe to be Patriotic Blue paint. If it is anything like the PT Cruiser Patriotic Blue Paint it is some hard clear. I intend on using SYN 1 and following it with perhaps SSR 2. I`ll try to snap a few pics of the finish after the SYN 1 and before the SSR 2.

**Dtrick.22** · 06-28-2010, 10:18 AM

Originally Posted by TroyScherer

Steve,
Can you give me an idea of the cut and finish ability for Syn1? Does it cut like SSR2.5 or 3? Also what should it finish down compared to? I want to make sure I am fair in my evaluation. Thanks

I think it cuts like 2.5....It just does it in half the time. The product will clear much quicker than SSR2 or SSR2.5, also something I like...But I still had to follow up with SSR2 to get the full clarity back, although it finished up better than I expected

**Poorboy** · 06-29-2010, 10:26 AM

Originally Posted by G.T.Subie

Will this be available at the Detail Weekend

Yes, we will have Syn1 available to use

**TroyScherer** · 06-29-2010, 10:45 AM

My new 5.5 LC Flat pads are scheduled to be delivered today. I can`t wait. Its killing me to have this stuff sitting on my bench and not using it. I wanted to wait as I am switching from 6.5 pads that came with my kit when I bought my PCxp. I hope to have a test done within the week.