In the lighting that I had it had appeared that I was getting the desired results when I did my test section so I ran with it.
What I have already done.
Wash, IPA wipedown, Clay,
Makita rotary, Menzerna Power Gloss, orange LC CCS 5.5 pad, 3 section passes @ speed setting 3.5 (about 2000 PRM) I did this twice on all panels so actually 6 section passes total.
Makita rotary, Optimum Polish 2, white 6 inch Edge 2K finishing pad, 3 section passes @ speed setting 3.5 (about 2000 RPM)
Flex 3401, Optimum finish polish, Red LC VC finising pad, 3 section passes @ speed setting 6 (full speed)
While there has been a significant improvement in the finish we are still left with a lot of scratches that have not been removed. I am not talking about RIDS but overall scratches. I know that Power Gloss is an aggressive diminishing abrasive compound but I really thought it would have had more effect than what it did.
Bookmarks