This is for some of the new folks out there learning.:
1- Turn your polisher upside down so the bottom of the pad is facing up at you.
2- Place the Pad Conditional Brush in your right hand.
3- Spin the pad slowly, between around 1000 - 1500 rpms or with a PC then
speed 2-3 on the dial.
4- Rest the bristles of the brush at the center part of the pad.
5- Pull the Pad Conditional towards you and away too, and repeat allowing
the brush do the work for you.
6- Always conditional your new wool pads ( with a Spur or Wire Brush ) before you use them and also periodically during buffing to help maintain the maximum effort and life of the pad and to get a swirl free finish.
7- And last always wash out your pads after you finish using them.
Hope this helps some of the new folks out there............
Bookmarks