The kompressor pads have a detent for the backing plate which -should-mean that they center better than the regular ccs pads, which, should mean that there is less vibration with the kompressor pads, tak/nie (yes/no)??
Will be used on pc 7424
The kompressor pads have a detent for the backing plate which -should-mean that they center better than the regular ccs pads, which, should mean that there is less vibration with the kompressor pads, tak/nie (yes/no)??
Will be used on pc 7424
AutopiaForums is the place to be.
Remember to Shop Autopia-CarCare.com for your Detailing Needs!
I am working on some prototype smaller Kompressor pads. They are approx 4.25 inch in diam that work with a 3" BP.
Thanks guys.
Angelo, do you like the pads on the five inch plate for any particular reason? and doesn`t the smaller plate make the pad less likely to center itself than if it were on the six inch plate??
Well to tell you the truth, I love using my Meguiar`s W66 Rotary Backing Plate 5.75? , and your right about the the centering part. Me so dumb forgot my BP is almost 6".......but you can use a 5" BP with them if you don`t have one bigger.........................Angelo
AutopiaForums is the place to be.
Remember to Shop Autopia-CarCare.com for your Detailing Needs!
It`s just a little tight for me using a reg` 6" BP. It`s just me I think. Maybe someone else can come in and say what they use....
AutopiaForums is the place to be.
Remember to Shop Autopia-CarCare.com for your Detailing Needs!
Yes there is definitely less vibration. However, I have found that the pads start separating around the indent after only a few uses. Is that normal? So far I have had 2 black pads and 2 white pads completely separate and I had to toss them. Not sure if this is to be expected or not. I sure hope not.
Otherwise the pads are excellent! Less work, less pressure, better cutting and virtually no heat on the PC.
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks