Lake Country Variable Contact (VC) Pads?

[tguil]

I came across a set of 6-inch Lake Country Variable Contact Pads (cutting, polishing, waxing) that I bought when I first started using a Porter Cable 7424. These were the recommended pads at the time. Over the years I pretty much switched over to 6.5 inch Meg`s pads.

Anyone still using these Variable Contact pads and do they have a place using a 7424 PC with the most up-to-date products?

[Ronkh]

I love my vc pads

[Todd@RUPES]

They still work the same as they always have and will work fine with new products. The movement has been towards flatter faced designs (both CCS and Flat).

[Dr Oldz]

VC pads rock with a rotary! Still one of my favorite pads. On a DA they really are not beneficial tho.

[ShawnF350]

I`m going to try my VC pads on my Makita this weekend.
I was shown at PB detail weekend to use the outer flat edge just tilting a few degrees?
Does anyone lay the pad flat against the panel.

[Ronkh]

Only use em on my flex

love em

use different ways for different areas