this is a very much detailed, and informative write-up. thanks a lot Todd
A little question however,
Can we do machine sanding with the Flex 3401?
this is a very much detailed, and informative write-up. thanks a lot Todd
A little question however,
Can we do machine sanding with the Flex 3401?
That was a great read Todd, I wish I had an article like that when I was just starting out!
Get your shine on!
when using CG hex logic pads, whats best with M105/M205? right now im using WG TSR 3.0 and Finishing Glaze..] soon to be moving up
Terrific write up Todd! I personally have switched from M105 to M101. M101 doesn`t seem to dust as much. I follow this up with Menzerna 4500.
I wouldn`t recommend it. The lack of a free-spinning bearing means that the rotation will be driven which could drastically increase the amount of material removed. Additionally, the driving motion of the machine will likely be amplified and the chance for pig-tail scratches would be very high.
Are the orange hybrid pads similar to the orange hydro-tech pads? Or is the blue hybrid pad close to the orange hydro-tech pad?
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks