Pad recommended with SSR 2 and SSR 1

[Poorboy]

not a fan of wool for anything but polishing .. make sure your wash process is also a back and forth motion to prevent swirls when you are moving dirt ..

[WuNgUn]

Lots of high pressure water before I even touch the car...
And straight back and forth/up and down as best I can.

Sent from my SM-G935W8 using Tapatalk

[Poorboy]

Lots of high pressure water before I even touch the car...
And straight back and forth/up and down as best I can.

Sent from my SM-G935W8 using Tapatalk

try only back and forth .. no up and down or curving on sides

[WuNgUn]

Oddly, it`s most visible on the sides/rear bumper. Of course, everywhere else has more sealant/wax protection.
Ugh! That`s it for this year... No more polishing until next spring. I`ll just try to minimize and damage until then.

Sent from my SM-G935W8 using Tapatalk

[Poorboy]

Oddly, it`s most visible on the sides/rear bumper. Of course, everywhere else has more sealant/wax protection.
Ugh! That`s it for this year... No more polishing until next spring. I`ll just try to minimize and damage until then.

Sent from my SM-G935W8 using Tapatalk

as long as your car looks better than the 99% around it`s ok

[WuNgUn]

By the way, that`s front to back on the top surfaces and up and down on the sides of the car. I think this makes swirls less visible in direct sunlight...?

Sent from my SM-G935W8 using Tapatalk

[Poorboy]

By the way, that`s front to back on the top surfaces and up and down on the sides of the car. I think this makes swirls less visible in direct sunlight...?

Sent from my SM-G935W8 using Tapatalk

actually always back and forth .. even the sides .. light refracts off of curved lines , if the lines are straight back and forth no refraction .. I think up and down has more of a tendency to not be so straight