How to clean your foam cannon

[hamza7]

I first thought I owned a Riccardo Foam Cannon but after closer inspection it`s just a MTM Hydro. Basically I saw PB`s new foam cannon video and decided to clean my foam cannon.



What you`ll need for this

• Foam Cannon
  
• A small L key or other small diameter tool
  
• 7/8th inch spanner or wrench
  
• Patience
  
• CLR
  
• Tooth brush or similar
  

I removed the bottle leaving me with the head only







This is the first pin you need to push out with your small diameter tool















Now slowly YANK the black spray adjuster out



















Next take your 7/8th inch spanner and grab hold of the the brass thing you see in the picture







After you release the initial tension you should be good to just loosen away by hand











Can you see the little metal filter inside that piece







I use the end of a L key to push it out









Pop, it came out













Can you guys see that filthiness















Next put that piece inside disposable bowl, if you have a plastic one it`s way better as I found out that CLR eats away at these things so I

changed it



















Make sure you coat everything







Here I changed the bowl







After 12 hours of dewll time











I then ran it under warm water with an old toothbrush to really make sure I got it clean. It`s good as new now

[tssdetailing]

Did you say this will work on an Autogeek cannon too? Great write up-i could have used it a month ago!

[hamza7]

Did you say this will work on an Autogeek cannon too? Great write up-i could have used it a month ago!

Sorry I don`t have knowledge of the AutoGeek foam cannon but if looks the same with the same sort of fittings then it`s probably going to the same procedure more or less