Originally Posted by
Brownie
Each formula represents a unique blend of specified Sub-Micron Abrasives. I don`t want to pull the "proprietary card" out on you, but there is a little of that which limits what I can share. One could almost think of it as a two-speed Power Glide Transmission. The Correcting Creams feature agglomerates which deliver sustained cutting power.... there are multiple variables which will drive how long the initial cut sustains itself... Pad Selection, Tool Type, Paint Finish, etc. The initial cut will occur during the first 3-4 full passes (one pass=back and forth) on a complete 2`x2` working area, semi-diminishing to its spec`d sub-micron size. Remember, the Agglomerate are simply multiple sub-micron abrasives bonded together.
It is always important to spread a full film of product across your working zone, prior to beginning full speed correction. There is a point where the abrasive will not break down further. This is where the Sub-Micron comes in. As I`ve mentioned before, the particle is so small, that the microscopic defect it may leave can not be seen by the naked eye under any lighting circumstance. Hope that offers some resolution to your question. Thanks Mark!
Bookmarks