found my swirl remover combo for the pc!

[Thomas Dekany]

Just about started raining when I buffed EX+P off and the owner had to go somewhere so I`ll do the interior next week (she is my next door neighbor).



nxt wash

rock hard clay - 2 hours of it the paint had so much s$$t on it.

(it was freezing this morning but 2 sweat pants and 4 sweaters helped)

ssr3 with my new orange pads from TOL on 6 (the polishing pad just didn`t cut it)

ssr1 with white pad on 6

ex+p by hand

couldn`t apply natty`s due to the rain drops

This Maxima was full of swirls - worse horizontally but ssr3 with the orange pad got rid of all the swirls in one pass. I am not sure how hard nissan paint is and aware that white paint is hardest in general but I couldn`t believe how effective this combo was! Saved me lots of time. I can`t wait to use them on other cars now. Anyways, herte are some very cloudy photos.



before









after claying







after







before







after







before







after

[Thomas Dekany]

[imported_kgb]

Looks good. You went right from #3 to #1 huh? I always go to #2 first. Looks like it worked for you though.

[Thomas Dekany]

thanks! I am not even sure if this was a paying job so I didn`t do ssr3/2/1, but ssr1 sure cleaned up everything ssr3 left behind.



The car came out very wet and shiny. Too bad the resized pictures don`t show everything.

[tangix2001]

Very nice work.:xyxthumbs

[mtodde]

Great job! I don`t think I`ve ever seen swirls like that on white paint.

[6']['9]

looks good, i like the way you kept the angle of the pic in the before and afters.

[hirosh]

great job. how does SSR 3 compare to SSR 2.5? thanks.

[Thomas Dekany]

thanks everyone - at one point I came home for a few minutes earlier tonight and the car was parked close to ""some light"" in the parking lot and I noticed that I left some swirls behind in the middle of the hood and some hazing as well. One reason why I don`t like cloudy days. Even though I looked so hard!

Anyways, inspecting the rest of the car (as much as I could) looked good.

So I`ll use ssr2 on the hood after getting rid of the remaining swirls.

[Thomas Dekany]

Originally posted by hirosh

great job. how does SSR 3 compare to SSR 2.5? thanks.

Much more agressive.



send me your address - I`ll send you some.

[vdog0531]

wow man, your work is great. you have had lots of details recently and your work is top notch! keep it up! i am also trying to decide if i want 2.5 or 3. i have 2 and 1 and really like them so far. again, awesome work!



Vernon

[Thomas Dekany]

thanks Vernon - try both products - ssr3 is good to have around just in case.

[Thomas Dekany]

here you should be able to see the contemination that was all over the car (black dots). Also see how flat the paint was.

[Antonio Wright]

Amazing work!

[Thomas Dekany]

I just got home froma detail and saw that I have to redo the horizontal areas. So I am sorry if I misled anyone about gouing from ssr3 to ssr1.



I did take some pictures before leaving though. It was sunny







roof







trunk