A "Must Have" for low profile vehicles!

**thecarter13** · 10-15-2009, 02:43 PM

Actually I think I have that coupon in a mustang mag. It is a nice looking jack for sho

. Actually there might be one for a air compressor in there too. The mag I have had one for a decent looking one. I think it would be a perfect one if your looking to use it to blow air from crevices or blowing off polish dust. Ill get more info and post back up

**imported_Luster** · 10-15-2009, 02:45 PM

Originally Posted by FJF

I was looking at the same jack, but the 3000lb rating concerns me.

I never leave the car up on the jack... I always use jackstands once I get it up in the air.

**imported_RaskyR1** · 10-15-2009, 03:19 PM

Nice!

Yeah, I could have used that last weekend on the C6. We had talked about removing the wheels but my jack wouldn`t get under the car.

**imported_Luster** · 10-15-2009, 03:21 PM

Originally Posted by RaskyR1

Nice!

Yeah, I could have used that last weekend on the C6. We had talked about removing the wheels but my jack wouldn`t get under the car.

Yeah, they`re pretty low. I`ve had to drive mine up on 2x12`s to get my old jack under the car!

**imported_RaskyR1** · 10-15-2009, 03:29 PM

Originally Posted by Luster

Yeah, they`re pretty low. I`ve had to drive mine up on 2x12`s to get my old jack under the car!

I though about doing that too but I was pretty confident I could clean the barrels with my EZ brushes.

Off topic....

I didn`t like the rough textured look of the stock wheels in the barrels...not sure why they did that.

ut:

Sure made cleaning a PITA

**imported_glfahlc** · 10-15-2009, 04:06 PM

nice find bill.. i`ve always put mine up on stands once i get it up....

**imported_Flash Gordon** · 10-15-2009, 04:58 PM

I got 1 of those a Year ago, the hydraulics blew out shortly after. HF replaced it no problem, but I am done with HF and Northern Tool. They sell nothing but junk IMHO

(ALWAYS USE JACK STANDS, EVEN IF YOU DON`T THINK YOU`LL NEED THEM)

It is very pretty though

**imported_broker99** · 10-15-2009, 06:20 PM

I saw that at HF and was wondering about it. Nice find Luster. I agree HF was good buys. I bought my paint meter there.

**imported_Luster** · 10-15-2009, 06:38 PM

Originally Posted by RaskyR1

I didn`t like the rough textured look of the stock wheels in the barrels...not sure why they did that.

ut:

Sure made cleaning a PITA

Until a few years ago, chrome plated wheels were chrome plated all the way back to the backside of the wheel.

GM Board Meeting:"Lets just chrome plate the front two inches... we`ll save millions!"

Chairman of the Board: "Brilliant!"