when using the claybar i just wanted to make sure i`m doing it right with the following steps:
1) Put a quick detailer (as a lube) on 2X2 section to work one.
2) Clay over the lubed area
3) work other sections until all of vehicle is done
Now i have a few quesitons about the following steps:
Question for Step 1:
How much detailer am i supposed to use on each section?
Question for Step 2:
What is the correct method to clay? How much pressure should i put on?
Question for Step 3:
After I clay a certian area, can i immediately wipe off with MF towel? Or will i have to let it set for a while?
Thanks!
Bookmarks