Hello and good day everybody.`
in the past I have 3M` PPF installed on my` last ride for 4.5 years` with no issues over that period.
`Little over a week ago` had an Xpel ultimate ppf installed on my new ride covering the whole front of the car.
The install was good except I have a small area on the rear of the hood where the edge of the film is lifting.
The next day after` the original install I noticed it and ran my finger over it to see if it would stay down and it did for a little while.
Seems like the edge of the film stops just past the hood on a round section .
Any ideas on how I could get the edge to adhere better, wet with solution and try and get it to adhere?
Hate to take it back to the original` installer as it would be another 4hr drive and the cost of gas but at the same time I want it to last and not peel up.
Figured I would ask here before calling the installer and demanding they fix it and reimburse me for the hassle of having to come back.
Bookmarks