Pads for gg3

[2quikta]

What pads are everybody using for the gg3? I was looking at the 3" LC flat pads, but are there better? You can get a 6 pack of the LC flats for $20

[Civicclutch]

I like the way the hd pads by lc work with my rupes but I can check em out on my gg3" on Tuesday


Sent from my iPhone using Tapatalk

[RaydiantDetail]

I dont have a gg3 but I use the 3" boss pads on my rupes lhr75 and they work great.
I am sure they would work equally great if not better with the gg3 since they are griots pads

Griots Garage 3 inch BOSS Foam and Microfiber Pads - 6 Pack

[TheMeanGreen]

What pads are everybody using for the gg3? I was looking at the 3" LC flat pads, but are there better? You can get a 6 pack of the LC flats for $20

Get as flat pads as possible. I currently use the LC 3" CCS and they are a little more than the GG3 can handle. I am currently looking at the BOSS 3" system, but have a better feeling that a 3" MF cutting or polishing pad will yield the best results with the GG3, as well as getting the BOSS 2" backing plate for their small air rotary. In order to make this *jiggler* effective, we need it to spin the least amount of mass as possible.

[TheDetailer718]

I have the blue rupes microfiber pad for cutting and yellow foam pad for polishing. Never had an issue with this setup.

[Accumulator]

I have the GG *pneumatic* and I`d use whatever MF pads are available (I`m still using Meguiar`s ones) and I also like the 3" foam pads from GG.

I dunno about the GG *electric* 3"...my first one died after a few minutes and the replacement is, well...basically useless.

[2quikta]

Well I ordered the LC thinpro 6-pack. We`ll see how they do!