Urethane lip problem

[Greg Ayo]

Hey everyone.



First off. Sorry if I put this in the wrong place. Mods please move it if you need to



I baught a poly urethane front lip and installed it. Unfortunately I didn`t secure the middle properly and when I was driving wind pushed it down and it was scraping the ground. Once I got a chance to stop and get out to look. I saw their was a bite about a foot long out of the lip.







You could see what I mean. In the middle where it goes up. That`s where the lip was damaged.



Does anyone know how I could fix this?



I heard of some people doing plastic welding or something like that. Any ideas are welcomed!



Thanks!

[David Fermani]

Sorry, the only way to fix that is by replacing it with another one. If it was a painted piece and you still had the chunk that broke off then maybe, but because this is semi-textured (?), you`re not going to be able to do anything.

[Greg Ayo]

Sorry, the only way to fix that is by replacing it with another one. If it was a painted piece and you still had the chunk that broke off then maybe, but because this is semi-textured (?), you`re not going to be able to do anything.

It isn`t textured. I plasti dipped it

[CGdetailing]

If it is poly, and not abs plastic, you might be able to let it sit in the sun and let it heat up to reshape it back to the original form.

[Greg Ayo]

Fixed ! What do you all think

[POPPAJ]

They should all look like that!