Pontoon Boat Help Needed

[Rob Preston]

ve only cleaned a few boats threw out my years of detailing. But never, will I do another pontoon boat again after I`m finished with this one. Trying to get the oxidation out of this thing was a pain in the rear. On the pontoons I used 1/2 a gallon of auto magic`s spoke & chrome wheel acid and 4 bottles of Mothers Bullet metal polish. Acid bath the pontoons as the local dealer recommended. Pressure washed the topside seats, floors, console along with scrubbing the seats. Drying and dressed everything. Then on to polishing the metal. This was time consuming but worth every bit of it. My prep for the pontoons acid wash 50/50 mix then 3M`s marine aluminum polish & restorer with my rotary (wool cutting pad) at 2400 rpms as instructed) then Mother`s bullet with a wool polishing pad at 3000 rpms. You can judge the results for your self. I`m looking for suggestions around the front end of this thing. I`ve tried using an 8 and 6-inch pad in this area and is vary difficult to do. Is there another tool out there that you guys use to get into tight areas? Thank you in advance.

I charged this guy $550 to this. I have 6 hours into so far.