here is after shots...Still see a little work I need to do on fender..but first time using PC..
here is after shots...Still see a little work I need to do on fender..but first time using PC..
Went over went SSR2 3 times and it sill left so spiderwebs...probably 90% gone...Is that the best I can get with a PC or should I go DACP?
Looks great - With SSR2 be sure your working in small enough sections 2`x2` or 3`x2`. I use the polishing pad and the work the product in at speed 3. Then set it to 5.5 and work the directions (left to right horizontally, right to left vertically, then diagonally from upper left to lower right - then lower left to upper right). Working at a slow steady pace with light to moderate pressure (I keep one hand on the PC base and the palm of my other hand on the back of the bend part behind the backing plate.) Working in those directions the SSR2 should go from liquid stage to powder (almost gone from the surface). Inspect the area for swirls - if they are gone move on if you still see some - try another pass using the same technique. Hope that helps but it really looks great from the pics!
You have activated my special ability....
groebuck. How long do you work an area before moving on?
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks