Anyone See This Link?

**Beemerboy** · 10-20-2008, 11:03 AM

I saw this posted on another forum..looks like some decent detail info

Main Page - DetailingWiki

**BlueZero** · 10-20-2008, 01:12 PM

I came across that the other day too. I`ve seen TOGWT post on other forums before. Seems to have some good info.

**Beemerboy** · 10-20-2008, 01:19 PM

Originally Posted by BlueZero

I came across that the other day too. I`ve seen TOGWT post on other forums before. Seems to have some good info.

this was on a BMW forum, posted by TOGWT

He seems to have a lot of detail knowledge documented.

**jaybs02** · 10-20-2008, 05:38 PM

can`t be that good .... It doesn`t have DC listed on it

**CharlesW** · 10-20-2008, 06:07 PM

TOGWT was/is a member here, but hasn`t posted for several years.
His leaving may have not been the most cordial.
I don`t remember any real problems, but all that means is that I don`t remember.

**Beemerboy** · 10-20-2008, 06:13 PM

Originally Posted by CharlesW

TOGWT was/is a member here, but hasn`t posted for several years.
His leaving may have not been the most cordial.
I don`t remember any real problems, but all that means is that I don`t remember.

Charles

I have watched to guy post in a couple of forum for a few years...it appears that he is very well documented on his detail process and chemical knowledge...However I find it just a cut and paste more than actually experience...the later in the two is more of what I would be looking for...The link is a good reference for lots of things..

**Smokin' Mark** · 10-20-2008, 07:12 PM

WOW...very useful for a Newbie like me.

**black bart** · 10-21-2008, 06:40 AM

Originally Posted by Beemerboy

Charles

I have watched to guy post in a couple of forum for a few years...it appears that he is very well documented on his detail process and chemical knowledge...However I find it just a cut and paste more than actually experience...the later in the two is more of what I would be looking for...The link is a good reference for lots of things..

Exactly cut and paste in most of his post.

He posted some cut and paste on MOL that was not correct and Mike Phillips really took him to the wood shed over it.

I think his Post is still in Myths & Confusion on MOL
Look in the good and bad silicone thread.

I don`t think he posts their anymore.

**Bunky** · 10-21-2008, 07:09 PM

I have challenged some of his assertions (like pad porosity is the sole determination of cut or his comment about AG green vs LC green). He never updated his post.

I had first hand info from Eric at LC on both counts. It comes across as factual in the way it is written but I would not consider it gospel.

He is trying to do a service but at the same time like everything some information is opinion in many cases.