I have not done any paint correction on my plastic bumpers (or metal sides) yet. Do I do the plastic at the same speeds with my DA as I did the metal hood and trunk?
Here is a better picture. I`m sure the black car owners know what a difference various lighting makes in these pics.
https://ibb.co/8mm1qZ6
Streaking can be due to over application of product (most of the time), products having different synergies, or humidity. Over application and humidity can usually be cured by buffing. If products don’t mesh the only solution is to stop using one of them.
I used 12 different SiO2 sprays on bare paint and had only one problem with streaking. Gyeon Cure gave me problems due to its thickness and I should have applied much less, so really over application.
Pretty much like poor boys always stated if you are getting streaking with spray and wipe you are using too much.
Problem can be though trying to do too much with a detail spray that is streaky if used over concentrated and you may end up not having enough wetness to get the dirt and dust lifted up from the paint.
You can also try to dilute a small amount of detail spray say 2 oz with 2 oz of distilled water and see if that helps.
Could it be stuff on the buffing towel causing the streaks. Some paints just to seem to like a very little product or have to follow with an additional buffing towel
For glaze you can try prima amigo or Adams glaze
Sent from my iPhone using Tapatalk
Post Thanks / Like - 1 Likes, 1 Thanks, 0 Dislikescorvetteman71 liked this postcorvetteman71 thanked for this post
I think you guys are right. I think I was not only using too much spray but also too much polish and wax. I did my sides and bumpers today with polish and wax. I started using less and the job got easier in general. My car is looking good. Not show car quality good but good for the guy down the block who is doing this all with an injured arm. This board has been a great help! 20 years ago I used to be on this board all the time. My original name was the same minus the 71. Seems it did not make the transition. Anyways thanks a bunch to you all! It is nice to be back.
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks