3D Upholstery & Carpet Shampoo with LGM Pro Heat

[Bill1975]

I plan on picking up a Bissell Little Green Machine Pro Heat, and the first use will be on cloth seats with some light staining. I have read threads about using Megs APC and Folex, but I have a bottle of 3D U&C Shampoo that worked well on some carpet floor mats I cleaned my hand. It does get a bit sudsy, but would there be any problem using this on cloth seats with an extractor?

My plan is to brush and vacuum, then scrub the seats by hand, and extract with the LGM using only water with no cleaner in the tank.

I know the LGM says to add their cleaner to the tank but most people here suggest not doing so. Thoughts?

[Bill1975]

Had a chance to use this combination today. I mixed up the soap and water in a spray bottle. It seems if I spray a little bit, I don`t know of it is enough. In other words I don`t see the suds on the seat cloth, but if I use more, it is very difficult to remove entirely.

My process was to use the 3D interior cleaner, sprayed on to the fabric, and agitated with a stiff plastic bristled brush, then rinsed and vacuumed using a Bissell LGM Pro Heat with only water in the tank.

The resulting water in the tank was very dirty, so there was some success, but visually the seats didn`t look that much different afterwards.

Sent from my HTC One M9 using Tapatalk

[Ronkh]

Look at it when it`s completely dry.

[grungy]

Look at it when it`s completely dry.

Exactly what Ron says - wet seats won`t show as well, plus if you have bleeding back from the foam it will not been seen at this stage.