Procedure? + more ?s

[pontman43]

To start I have a 97 trans am with black accents (with the most swirls, but not too bad) the rest of the car is a mystic teal metalic (moderate swirls from the body shop). Half of the paint is new, so I wont be doing all this for another couple of weeks. I also have black wheels. And there is not one scratch, so I dont have to worry about fixing that.

OK, now I think I know what to do, but I still have a few questions.

Here is what I want to do in the order I think it should go.

-Wash

-Clay

-Polish with 2.5 with propel green pad on speed 5.5-6 with PC (little pressure)

-Polish with turtle wax 2001 urithane polish (light polish, that I actually like) with blue pad speed 5 with PC (little pressure)

-AIO by hand w/MF applicator

-Sonus Glaze (the new stuff, like #1 or #3) by hand

-P21s by hand



And all of this with little time between. That is my other question, do any of these products need to set?

Are all of these in the right order, mainly questioning AIO and Sonus Glaze.

What else is there that will make the finish look better? Not too worried about protection.

Also is there any suggestions as to getting a black perfectly swirl free?

And lastly are there any suggestions for the new paint?

Thanks a lot

[pontman43]

Anyone have any advise??

[jimmybuffit]

Me?

Lose the Sonus Glaze (?), and substitute Klasse Sealant Glaze. Wait 24 hours, reapply, wait 24 hours, then apply P21S/S100



Worth the effort!



Jim

[pontman43]

I guess I should have gotten the KSG at the same time as the AIO.

Any more suggestions?

[pontman43]

nobody else, huh?