Blemish removal

[SVR]

I have a couple bad blemishes on my car`s finish that were there when I bought it back in august

Most of my work is done by hand. I have a pro rotary but need some edge 2000 pads and more practice, however my new job (if i get it) will give me the training I need.

Is there a point when you have to break out the rotary to get blemishes and certain scratches out.



I am currently refinishing the PPG 2K clearcoat galaxy blue metal flake paint as I was lazy when I first got the car and skipped some steps

This is what I am doing, have been doing it panel by panel due to time restraints.



CM clay

4 Star UPC (an extra fine cut might be required but I don`t want to)

Poorboys SSR 3, 2.5 X 2, 2.0, Meg`s #9, Menz IP/FP, Dinitrol 7020 polish, klasse aio, sg x 4, upp x 2, wolfgang x 2



Alot of steps I know but the finish so far is awesome with the four klasse sg`s on the completed panels so far. Left side doors to go yet.



This pic was done with flash on as the light was bad in the shed

Please give me a quick run down on what I need to do to remove these things.