2001 Mustang Bullitt Detail (56k Warning)

[29bullitt59]

Hi All,



Here are some before and after pics of a detail I completed last week. This is what I did:



Dawn wash each panel

Clayed using Mother`s Clay Bar

3M SMR w/PC, orange pad, setting #4

GEPC w/PC, white pad, setting #4

Mother`s Sealer & Glaze, w/PC, white pad, setting #4

Meguairs` Tech Wax by hand

and topped off with IBIZ Car Wax (carnuba based)



I removed each product using a microfiber towel. In the first set of pics, I tried to capture as best I could the swirl marks.



http://www.autopia.org/gallery/data/500/5561hood1-a.jpg



http://www.autopia.org/gallery/data/500/5561hood2-a.jpg



http://www.autopia.org/gallery/data/500/5561frontbumper-a.jpg



http://www.autopia.org/gallery/data/500/5561rearbumper-a.jpg



http://www.autopia.org/gallery/data/500/5561rearquarter-a.jpg



http://www.autopia.org/gallery/data/500/5561roof-a.jpg



http://www.autopia.org/gallery/data/500/5561trunk1-a.jpg



http://www.autopia.org/gallery/data/500/5561trunk2-a.jpg

[stilez]

Awesome sunny shots :cool:



Car looks good to me :up .



How do you like Ibiz? I used to use that stuff back in the day...Forget how it was.

[29bullitt59]

Here are the pics after I finished detailing:



http://www.autopia.org/gallery/data/500/5561hood-b.jpg



http://www.autopia.org/gallery/data/500/5561frontbumper-b.jpg



http://www.autopia.org/gallery/data/500/5561rearbumper-b.jpg



http://www.autopia.org/gallery/data/500/5561leftquarter-b.jpg



http://www.autopia.org/gallery/data/500/5561roof-b.jpg



http://www.autopia.org/gallery/data/500/5561trunk-b.jpg



As you can see, I still have some swirl marks. I think I got most, but when I first got the car, I wasn`t as careful as I should have been (pre-Autopian days). Some of the marks are too deep even for a rotary (which I do not own). I haven`t tried wet sanding because this is my daily driver and is outside 24/7.

[29bullitt59]

And here are some pics of the whole car:



http://www.autopia.org/gallery/data/500/5561front-b.jpg



http://www.autopia.org/gallery/data/500/5561leftfront-b.jpg



http://www.autopia.org/gallery/data/500/5561leftside-b.jpg



http://www.autopia.org/gallery/data/500/5561leftrear-b.jpg



http://www.autopia.org/gallery/data/500/5561rightside-b.jpg



http://www.autopia.org/gallery/data/500/5561rightrear-b.jpg



http://www.autopia.org/gallery/data/500/5561rear-b.jpg

[29bullitt59]

GSRstilez,



The Ibiz products I have aren`t too bad. I have their car wax, waterless car wash, tire dressing, and interior dressing called Sheen. Their wax and waterless car wash go on easy but do take a little effort to remove, certainly not as easy as P21S. I would say the protection is on par with P21S. I got these items while attending one of the car shows at Carlisle, PA a couple of years ago. Since I have it, I might as well use them.



Tom

[Thomas Dekany]

Hey - the right side of your car is black!! :D





Very nice work - how long did it take?

[gav'spurplez]

looks good. you are not the only one with a pony car that is a daily driver :(





me too, snow included :rolleyes:

[topnotchtouch]

Looks awesome, I have always loved the Bullitt :xyxthumbs

[1 Clean WS6]

AWESOME work 29bullitt59 and one beautiful Bullit to boot!!! :bigups

[jaybs02]

looks great:up

Nice pop from the metalic paint

[hirosh]

the picture of the c-pillar is awesome! and great job. :xyxthumbs



and i`m jealous of your bullit`s brake calipers. the bullits get the red ones with the pony, the cobra ones say cobra, yet the mach1 gets the ugly, plain grey ones. :nixweiss

[stilez]

I spoke too soon!!



I thought those were the afters!



The real after shots look stunning. Tons of flake jumpin out at ya :) . Nice work...don`t get discouraged about a couple swirls on a daily driver...It happens :up

[90 ZR-1]

Wow, that looks really good. Looks like mine when I was done with it. Great job.

[dhg5260]

The Dark Highland Green Bullitt is awesome... Looks great!!!