Dohhunter
06-21-2004, 10:48 AM
Ok, a car with a full IP/FPII detail is ready for glaze and waxing.
Couple of questions:
1) Hand apply FTG (finishing touch glaze), can or woudl it be beneficial to put two thin coats (for any micro marring fillin) possibly on before I put the FMJ sealant on? (what can i say, i`m a perfectionist :) )
2) If I have glazed and sealed (FTG and FMJ) and still find a couple of trouble spots in direct sun or certain lighting (ie. thin spider lines, a little marring etc.) can I IP/FPII right over the FTG/FMJ and then just redo the process in that spot?
Now as for post IP/FPII detail....
1) would there be any benefit for using something such as Klasse AIO before the FTG/FMJ? I used the 50/50 alcohol wipedown and such after the Menzerna but thought the AIO might add something?
Dunno, just some ideas popping out :nixweiss
Couple of questions:
1) Hand apply FTG (finishing touch glaze), can or woudl it be beneficial to put two thin coats (for any micro marring fillin) possibly on before I put the FMJ sealant on? (what can i say, i`m a perfectionist :) )
2) If I have glazed and sealed (FTG and FMJ) and still find a couple of trouble spots in direct sun or certain lighting (ie. thin spider lines, a little marring etc.) can I IP/FPII right over the FTG/FMJ and then just redo the process in that spot?
Now as for post IP/FPII detail....
1) would there be any benefit for using something such as Klasse AIO before the FTG/FMJ? I used the 50/50 alcohol wipedown and such after the Menzerna but thought the AIO might add something?
Dunno, just some ideas popping out :nixweiss