3saabtodd
05-20-2004, 11:11 AM
Greetings everyone,
I am going to put stongard on my headlights, corner turns, fogs and on a painted area of the forward part of rear wheel well.
My question is this....I just AIO, SG and topcoated with a layer of carnuba this past weekend. I applied the AIO to the light lenses. What do I need to do to get these surfaces ready for the stongard? What will remove AIO. I was thinking of wiping the lenses down with some rubbing alcohol. Would this remove the AIO? Any better ideas.
Also, any tips for applying the stongard?
Thanks in advance,
Todd
I am going to put stongard on my headlights, corner turns, fogs and on a painted area of the forward part of rear wheel well.
My question is this....I just AIO, SG and topcoated with a layer of carnuba this past weekend. I applied the AIO to the light lenses. What do I need to do to get these surfaces ready for the stongard? What will remove AIO. I was thinking of wiping the lenses down with some rubbing alcohol. Would this remove the AIO? Any better ideas.
Also, any tips for applying the stongard?
Thanks in advance,
Todd