MST3K
04-24-2004, 11:11 PM
I have some very very minor swirls from the one time I let the dealer wash it. You can`t even see them except under artificial light. It`s a metallic silver. I was thinking of the following sequence:
wash
clay
AIO
3M or Meguiar`s #9 SMR
SG
P21S
The reason for doing the SMR after the AIO is because it leaves fillers, and I guess if I did it before, the AIO would remove any benefit of the SMR. I don`t think I should use anything stronger like DACP for my situation.
Would the SG bond ok in this case?
wash
clay
AIO
3M or Meguiar`s #9 SMR
SG
P21S
The reason for doing the SMR after the AIO is because it leaves fillers, and I guess if I did it before, the AIO would remove any benefit of the SMR. I don`t think I should use anything stronger like DACP for my situation.
Would the SG bond ok in this case?