outdoorsr
09-21-2003, 05:48 PM
[Taken from www.zaino.com]
Applying ZFXâ„¢ Enabled Show Car Polish
Follow these easy steps:
Apply Zaino Show Car Polish enabled with ZFXâ„¢ with a 100%, made in the USA, cotton applicator. Use the polish sparingly. A small amount goes a long way, and you will be applying multiple coats.
Squirt a dime size dab of polish on your applicator and rub it into your paint using circular hand motions. Then, go over the same area using a straight back and forth motion on top panels and an up and down motion on side panels. Allow the polish to haze over (20 minutes is sufficient).
Buff off the Show Car Polish residue with a high quality, 100%, made in the USA, cotton detailing towel.
After buffing, spray the car with a light mist of Z-6 Ultra Cleanâ„¢ detailing spray. Z-6 will help buff away any remaining residue and enhances the brightness of the finish. Using Z-6, the next coat of Zaino Show Car Polish will apply even easier.
You`re now ready to apply your next coat of Zaino Show Car Polish enabled with ZFXâ„¢. There`s no need to wait. Simply follow steps 1-4 above one more time. Use a fresh cotton buffing towel to remove each coat of ZFXâ„¢ enabled Show Car Polish.
Note: Apply no more than three coats of Zaino Show Car Polish enabled with ZFXâ„¢ in a 24 hour period. For optimum results, use your ZFXâ„¢ enabled polish within 6 hours of mixing. Use a fresh cotton buffing towel for removal of each coat.
Note: When you are finished polishing, wash the mixing bottle inside and out with a heavy concentration of liquid dishwashing detergent and thoroughly rinse. The ZFXâ„¢ mixing bottles cannot be reused if the polish remains in the bottle for more than 12 hours. After 12 hours, it is not possible to completely clean the mixing bottle. Throw the mixing bottle and any unused polish contents away after 12 hours.
Does everyone agree with these instructions? Even though they differ from the back of the Z5 bottle.
Applying ZFXâ„¢ Enabled Show Car Polish
Follow these easy steps:
Apply Zaino Show Car Polish enabled with ZFXâ„¢ with a 100%, made in the USA, cotton applicator. Use the polish sparingly. A small amount goes a long way, and you will be applying multiple coats.
Squirt a dime size dab of polish on your applicator and rub it into your paint using circular hand motions. Then, go over the same area using a straight back and forth motion on top panels and an up and down motion on side panels. Allow the polish to haze over (20 minutes is sufficient).
Buff off the Show Car Polish residue with a high quality, 100%, made in the USA, cotton detailing towel.
After buffing, spray the car with a light mist of Z-6 Ultra Cleanâ„¢ detailing spray. Z-6 will help buff away any remaining residue and enhances the brightness of the finish. Using Z-6, the next coat of Zaino Show Car Polish will apply even easier.
You`re now ready to apply your next coat of Zaino Show Car Polish enabled with ZFXâ„¢. There`s no need to wait. Simply follow steps 1-4 above one more time. Use a fresh cotton buffing towel to remove each coat of ZFXâ„¢ enabled Show Car Polish.
Note: Apply no more than three coats of Zaino Show Car Polish enabled with ZFXâ„¢ in a 24 hour period. For optimum results, use your ZFXâ„¢ enabled polish within 6 hours of mixing. Use a fresh cotton buffing towel for removal of each coat.
Note: When you are finished polishing, wash the mixing bottle inside and out with a heavy concentration of liquid dishwashing detergent and thoroughly rinse. The ZFXâ„¢ mixing bottles cannot be reused if the polish remains in the bottle for more than 12 hours. After 12 hours, it is not possible to completely clean the mixing bottle. Throw the mixing bottle and any unused polish contents away after 12 hours.
Does everyone agree with these instructions? Even though they differ from the back of the Z5 bottle.