PDA

View Full Version : 2000 HD F-150 18,000mi. How`s it look so far?


bobkomas
08-25-2003, 05:12 PM
Up to this point

I`ve dawn washed, mothers clay bar and used PC to SEC it...

Next step will be AIW and SG with PC then S100 by hand...



Comments welcome:



http://vrcc.photostash.com/vrcc_8755/claybar_sec001.jpg.JPG



http://vrcc.photostash.com/vrcc_8755/claybar_sec002.jpg.JPG



http://vrcc.photostash.com/vrcc_8755/claybar_sec003.jpg.JPG



http://vrcc.photostash.com/vrcc_8755/claybar_sec004.jpg.JPG



http://vrcc.photostash.com/vrcc_8755/claybar_sec005.jpg.JPG



http://vrcc.photostash.com/vrcc_8755/claybar_sec006.jpg.JPG



http://vrcc.photostash.com/vrcc_8755/claybar_sec007.jpg.JPG



http://vrcc.photostash.com/vrcc_8755/claybar_sec008.jpg.JPG



http://vrcc.photostash.com/vrcc_8755/claybar_sec009.jpg.JPG
Pats300zx
08-25-2003, 06:14 PM
Very nice...:up
cpaddock
08-25-2003, 06:28 PM
Nice looking ride:up . Those are some cool pics.



Is the weather rough there in RI?
bobkomas
08-25-2003, 06:34 PM
Thanks,

The weather`s rough in RI only about 5 months of the year :)

Water here has lots of stuff added to it also which makes me hate washing because the spots are a Bit@@ to get off (still working on that "perfect drying" technique, but might try the QEW next time, I just picked up a bottle of it.)
SlvrChrm03Max
08-25-2003, 06:36 PM
:xyxthumbs Nice shine and nice truck !



Bob
imported_Simon
08-27-2003, 11:01 AM
That is one nice lookin` truck! Nice and wet looking too. Good job:up
imported_Tony
08-27-2003, 11:43 AM
Your truck looks great.



I dont think you can use SG with a PC. From what I understand SG has to set for at least an hour ( I wait overnight) before buffing. I dont think SG will bond using the PC method.



Anyway what do I know?



Good luck
2wheelsx2
08-27-2003, 11:55 AM
You can use the PC to spread the SG. However, I personally wouldn`t. It`s just a apply and let set for an hour. No buffing required. The foam pad would soak up and waste a lot of product too.
bobkomas
08-27-2003, 12:04 PM
okay, I may have gotten it mixed up with the AIW then, I`ve read that people use the PC for that. That`s okay, right?
2wheelsx2
08-27-2003, 12:09 PM
AIO may be used with the PC, especially if you are not using a polishing step. It`s cleaners work very well at removing oxidation.



I normally use it after a polishing step to clean off oils and fillers prior to applying SG, so I do it by hand.



Just make sure you use the "less is more" principle when applying both Klasse products and you can`t go wrong.



And remember to allow SG to cure for at least 24 hours per coat.