View Full Version : Toolguys, help... Rotary got wet... Help...
jerry@robs
08-20-2002, 02:50 AM
We had some serious flooding the past week or so and my 9227C got soaked.... i air dried it for like 4 days and then I tried to run it...
It worked but... it couldn`t maintain its speed... kinda like a hesitating engine... 2000rpm-1200rpm-1800rpm kinda rotation...
What should I do?
I`m pretty sure it needs to be opened up, cleaned and relubed... but I need specific instructions... Thanks guys.
ultrajim49
08-20-2002, 02:54 AM
Don`t panic
you did a good thing to let air-dry
i know what has to be done ,
I`m just looking to translate the right name for the thing to be cleaned.
Hold on a minute (or two)
jerry@robs
08-20-2002, 02:56 AM
Thanks a mil Christian... :)
I`m glad that the buffer still worked (didn`t short out) but I can`t stomach the fact that my 1 month old rotary is busted... :( :( :(
My shop.vac got wet too, but it`s a wet/dry vac and it worked fine...
ultrajim49
08-20-2002, 03:37 AM
Here we go:
check this page first and print it out :http://www.makita.com/res_tools/pdf/parts_breakdowns/9227C.pdf
first remove the carbon brush (number 42) and with fine (400-grid)clean them
remove screws number 11: the whole body should come apart
with the same sanding paper clean item 6 where the carbon brush touch
reassamble
test
let me know
From the spareparts list I see that the bearings are sealed ones : so no need to re-grease
edit: screws number 16&17 are wrong,
should be 4 screws number 11
oops
jerry@robs
08-20-2002, 03:40 AM
Thanks Christian...
but... (sorry for leaving this out)
would it void my warranty if I open it up instead of sending it in for repair?
Just wondering... I`m itching to open it up and clean it up before it gets rusty...
Your info is very helpful...
BTW, what`s part 404 (Sleeve 18) for?
ultrajim49
08-20-2002, 03:45 AM
as for warranty:
this is not a factory malfunction
so I`m pretty sure that warranty will not cover this
but to be on the safe side : asking your dealer could never hurt, could it?
Hope I could be of any help
Christiaan
jerry@robs
08-20-2002, 03:48 AM
makes sense... I`ll let you know what happens (still looking for the distributor/service center here) Thanks again
jerry@robs
08-20-2002, 05:26 AM
thanks ejant... i`ll do that...