After a 12hr cure time of WG sealant ?

[Mary B]

I`ll be using WG Glaze & Sealant on my DD Thur.
I want to apply WG spray wax. After the 12hr suggested cure time the truck will be dusty,
So I`ll have to wipe her down with :
Eraser (what I usually use)
OPT. PP ( have, not used yet)
or maybe WG Rinseless in QD ratio ?
Any suggestions or advise would be helpful :thanks

[jrock645]

Uber rinseless as a QD would be best bet i think

[WaxAddict]

Why use Eraser on freshly applied LSP? It`s probably too strong, as it cuts polishing oils decently well, which is what it was made for. It may cut through the LSP. ?

my go-to for a dusting in-between layers (of anything) is PB Spray & Wipe, as it leaves very little behind.

[rlmccarty2000]

The Uber would be my suggestion also.

[Mary B]

The Uber would be my suggestion also.
[emoji4] sounds good will do

The Uber would be my suggestion also.


Sent from my SM-S975L using Tapatalk