EXO v2 question

[Tung-Sol]

Hi all. I need help removing EXO, preferably without damaging/removing the C1 application below ... if this is possible? I`ve applied EXO to about 2 sq. ft. over a nice C1 application and it is streaking/hazing/whatever. I`ve searched, read and tried to apply it correctly, but apparently need more practice. I did give C1 12 hours to cure, maybe too long in this heat? All applications done inside out of sun though over 90 degrees in there. Any advice re. removing EXO and starting over most appreciated! Thx!

[RaysWay]

I would rather use a compound and make sure everything has been removed. I think your setting yourself up for more trouble if you try and only remove the EXO top coat.

[Tung-Sol]

Ok. Will I have to remove the entire panel of C1 as well, or can the 1/4 with EXO be polished off and then blend C1? Or just do C1 over the entire panel after polishing the 1/4 off?

[RaysWay]

I would polish the entire panel.

[Tung-Sol]

Ok, thanks. Generally speaking, what does it take to remove C1, aggressive compound like FG400 or something like Super Finish SF-4000 do?