Hold it or Wear it? Whats your Wash-mitt grip preference?

[Angus]

Just a quick poll to see how many of us hold a washmitt or wear a washmitt while preforming a traditional 2B or rinseless wash.

[PA DETAILER]

Hold.

[Migue]

Hold.

[Ronkh]

Hold

[jrock645]

Hold.

[512detail]

hold but I tried the pb wash mitt with my hand inside it because its nice and cuddly in there, haha

[JustJesus]

LOL - so far I`m the only one who wears it. Black Sheep

[Billy Jack]

I`m in the "hold it" camp.
My current favorite for rinseless is the Meg`s or Blackfire MF mitts. I haven`t used my Griot`s mitt yet. It`s thicker than the others, but it`s not white, so it`s more difficult to spot any residual dirt after rinsing. I`m thinking of including a MF Bone sponge in my upcoming order to avoid the cuff.
Any opinions?

Bill

[Marc08EX]

hold.

[briarpatch]

Wear it

[Accumulator]

Hold it shut at the cuff to retain the shampoo mix that I fill it with, which gradually seeps out adding to the flushing and lubrication provided by the foamgun. When it`s empty I rinse it out and dunk it in the shampoo mix to fill it up again.

When using MF mitts with IUDJ (no foamgun when using the rinseless) I still fill the mitt with solution and hold it shut while whisking it across the panels. But I don`t fill it with as much solution as I`ll swap it for a fresh one before a whole mittful of IUDJ could seep out.

[ViperGuy21]

Usually I hold it

[512detail]

I`m in the "hold it" camp.
My current favorite for rinseless is the Meg`s or Blackfire MF mitts. I haven`t used my Griot`s mitt yet. It`s thicker than the others, but it`s not white, so it`s more difficult to spot any residual dirt after rinsing. I`m thinking of including a MF Bone sponge in my upcoming order to avoid the cuff.
Any opinions?

Bill

I have a few bone sponges. I have used them for RW and I have another one I tried once with 2bm. both ways I liked but actually I had no reason not to use them again except I probably put them in a drawer and forgot about them

[skibik]

You didn`t give a third option, I do both. If I am in a hurry I hold it. When I am not I wear, use one side on a small area, give my wrist a quick twist and spin it to the other side and do another small area and rinse.

[512detail]

Hold it shut at the cuff to retain the shampoo mix that I fill it with, which gradually seeps out adding to the flushing and lubrication provided by the foamgun. When it`s empty I rinse it out and dunk it in the shampoo mix to fill it up again.

When using MF mitts with IUDJ (no foamgun when using the rinseless) I still fill the mitt with solution and hold it shut while whisking it across the panels. But I don`t fill it with as much solution as I`ll swap it for a fresh one before a whole mittful of IUDJ could seep out.

we need to send you a cameraman to document your wash method :)