sealthedeal
03-06-2015, 06:54 AM
Hi , I am going to be using this for the first time (I have prior experience with WC glass gaurd though). I will be using DP Glass restorer on a DA with a white CCS pad, Followed by Carpro Eraser and then DP Glass coating with a foam finger pocket applicator.. Have a few Questions:
1. How much of a criss cross area should be covered with a single spritz ?
2. How many spritz (approx) should it to take to cover an average windshield? I ask because I saw someone run into rainbow effect issues and "overapplied" was a general consensus in that thread.
3. Would layering benefit the durability/coverage (say an hour later) ? The intent is for it to last atleast last 6-8 months and stay hydrophobic in rain.
4. Does the applicator gets clean easily if you wash it rightaway (with detergent or apc) ? Would like the applicator to be usable again (even dedicated to glass) but just checking if any hardening happens here on the applicator.
Thanks
1. How much of a criss cross area should be covered with a single spritz ?
2. How many spritz (approx) should it to take to cover an average windshield? I ask because I saw someone run into rainbow effect issues and "overapplied" was a general consensus in that thread.
3. Would layering benefit the durability/coverage (say an hour later) ? The intent is for it to last atleast last 6-8 months and stay hydrophobic in rain.
4. Does the applicator gets clean easily if you wash it rightaway (with detergent or apc) ? Would like the applicator to be usable again (even dedicated to glass) but just checking if any hardening happens here on the applicator.
Thanks