HD Poxy reaction with clear bra material edges

[kajunman]

Quote: Originally Posted by Slickery



Now for the bad...



I haven`t had much issues with HD Poxy around moldings, but I have had problems with the plastic strips that dealers are putting on cars these days to avoid chips. The thin strips pull the HD Poxy out of the applicator and stain the edge just as shown in the picture. This occurred on every one of these strips I`ve used with HD Poxy.



I presume that the HD Poxy would cause the same problem on the edges of 3M like clear bra material. Has anyone else experienced this problem? Maybe someone from 3D would care to comment on this problem?



Thanks,

Kajunman

[kajunman]

I would appreciate it if someone from 3D would reply to this.



Thanks,

Kajunman

[gtpaul]

I dont think this needs a reply. It`s crucially obvious that most waxes will leave a buildup near a cut line on film like this. It`s grooved and can gather anything.

[Ben@3D]

Kajunman,



Not sure what I can tell you. It is best to avoid the edges of the plastic strips, tape off the edge, or use less product. This is the case with most waxes.



I have never experienced any issues with a 3M clear bra. Maybe some else can chime in if they have had issues and if they did anything differently?



Ben

[kajunman]

The reason I ask this about the HD Poxy as I have used Jeffs Werkstatt Acrylic Jet Trigger on and around Clear Bras with no Build up Problem.

Kajunman

[mikenap]

The reason I ask this about the HD Poxy as I have used Jeffs Werkstatt Acrylic Jet Trigger on and around Clear Bras with no Build up Problem.

Kajunman



You`re comparing a spray sealant to a liquid. Of course you won`t have build up with a spray, but like Paul and Ben have said, this is common with pastes and liquids.