Forever black users

[WCM3]

So I used this on my moldings last night and it was great on the smaller moldings. Pretty much dyed the moldings black again. However, on the longer moldings it left streaks. What do you guys do to make these streaks go away? Can I polish it with something, or should I just put another coat of forever black on it?



Any help will be appreciated!



Thanks,

Mike

[imported_steveo3002]

i found thier tire gel goes on more evenly



try putting some in a small bowl and wiping on a thin coat with a decent sized sponge..long continuous wipes so theres no edges



it might take a few thin coats to make it look even if the trims were bad

[WCM3]

i found thier tire gel goes on more evenly



try putting some in a small bowl and wiping on a thin coat with a decent sized sponge..long continuous wipes so theres no edges



it might take a few thin coats to make it look even if the trims were bad



**** I should have done that to begin with. I have a nice sponge that I use to shine up my tires that I can use. It should work. Thanks man.

[WCM3]

Just replying to my question. I did what steveo3002 said with a bigger applicator and it worked. There was still some streaks but I just let it dry for about an hour and then buffed it with a new microfiber. Didn`t get any black on the microfiber and it left an even shine. Thanks guys..