View Full Version : removing front plastic piece from PC
2000firebird
04-06-2008, 01:44 PM
i need to take the front black plastic cover off to i can fit the pc better into a tight spot i am trying to use it. how can you take this off without breaking it?
2000firebird
04-07-2008, 12:11 PM
bump.
piece on the front here.
http://ecx.images-amazon.com/images/I/314MH5GE2RL._AA280_.jpg
2000firebird
04-08-2008, 03:54 PM
anybody. anybody.
imported_Denzil
04-08-2008, 04:21 PM
I don`t think anyone has... let alone would it be safe to operate the PC with that plastic removed.
backwoods_lex
04-08-2008, 04:58 PM
When I ordered mine in a kit a few years ago, that part was loose and it makes noise when I crank it up. I would also like to remove mine or figure out a way to tighten it down.
BigJimZ28
04-08-2008, 05:36 PM
When I ordered mine in a kit a few years ago, that part was loose and it makes noise when I crank it up. I would also like to remove mine or figure out a way to tighten it down.
mine was loose also
so I went to a hardware store
and found 2 rubber washers, 2 flat washers
and 2 hex head cap screws
now it`s tight, no more "rattle"
2000firebird
04-09-2008, 10:32 AM
i need mine off so i can get it between wheel spokes
http://www.veronicabelmont.com/wp/wp-content/uploads/2007/06/halp.jpg
Setec Astronomy
04-09-2008, 10:37 AM
As Denzil alluded to, I suspect there are rotating gears under that cover...not good for fingers or wheel spokes.