Newbie to pc`ing needing product suggestions for black 97 Acura CL

[fliplyricist1]

Hi all, I`m going to be recieving the PC 7424 kit with CCS pads later this week, and have a flamenco black pearl 97 Acura CL with pretty good condition paint for the age. I always wash and wax the car every other week, but of course there has been a huge accumulation of swirl and scratch buildup that hand polishing/waxing could never remove.



So now I`m looking to eliminate all that or as close to all that as I can and bring it back to near showroom condition. My question is...what are the best products I should use to eliminate medium swirls and scratches on a 10+ year old black car? I`m not sure whether these older acuras had softer clearcoat or not, but just wanted suggestions on the best and easiest to work with swirl/scratch removers/pure polishes out there that will get yield me some good permanent results.



I`ve seen the tutorial vids on autogeek and was wondering how good an agenda the following is:



Pinnacle MXT 3 w/orange pad

XMT1 w/ white pad

topped with one or two coats of DWG for added depth and gloss

finalized with a coat of Victoria Red wax







How does this sound? I want the paint to look unrealistically wet. How do poorboys SSR products stack up to pinnacle? Or does anyone have any alternative suggestions?



Thanks much in advance

[fliplyricist1]

:nixweiss







: /

[detaildoc]

You can never go wrong with Menzerna. You can try IP or SIP with a white pad first, and if that does not do the job, move to an orange pad. You can then finish with either Final Polish or 106ff with the gray pad.

[fliplyricist1]

detail: thanks for the suggestions!



Ok, so here is my tentative lineup:





IP w/ orange pad

FPII w/ gray pad

DWG x2 applied by hand





how is dwg as an LSP? Also, I have heard stuff about x3 having a quicker cut and being easier to work with than FPII, any thoughts on this? And lastly, is there a place that sells both menzerna AND danase glaze?



thanks in advance