PDA

View Full Version : Rust in weird spots -- what to do?



altimaser
05-05-2007, 10:27 PM
I have some rust in some cracks and weird areas



See attached picture



any advice is appreciated



thx

imported_steveo3002
05-06-2007, 04:01 AM
ohh that will repair well



find a manual or forum for you`re car and find out how to dismantle that part, it might take a while but will just be nuts ,bolts n screws



once it off on the bench sand that area back until you see clean silver metal finish up with 400g, and then sand the whole piece with a scotch pad or 800g



spray on etch primer over the bare metal...allow it to dry and then sand with 800g to make it smooth, then spray on a few coats of semi matt black paint and allow to dry



if all that sounds too much, chances are a new piece isnt $$$$$$$ or you could pop off that lower trim and mask off the rest with tape

David Fermani
05-06-2007, 08:40 AM
That should really be replaced if it`s rusting. Give me a description of the car and I`ll tell you how much it costs to replace.

imported_Detailing Technology
05-06-2007, 09:13 AM
Listen to David, rust is like cancer. But first find the cause, it may be a poorly designed piece of trim above that area that funnels water to that piece of trim.