Strs90
12-07-2006, 12:05 AM
On just my third use of my PC the backing plate shot off. My first thought was that this had happened. (http://autopia.org/forum/machine-polishing/74006-help-backing-plate-broke-scratched-car.html)
Luckily it hit the wiper cowl and didn`t do any damage. When I looked closer I found that the screw had stripped on the backing plate...
My question is.. only the first 3 threads are stripped because thats as far as it tightened down with the spacer... if i remove the washer I still have atleast 4 perfect threads below that.. does anyone know if there is someway I could make this one work or find an adapter to fix it? I`m sure I can rig an extension to it but do you think that to dangerous?
FYI.. I was extremely cautious about not overtightening it so please dont rub it in... and I`ve wasted too much money on this "hobby" than I should already have...
Luckily it hit the wiper cowl and didn`t do any damage. When I looked closer I found that the screw had stripped on the backing plate...
My question is.. only the first 3 threads are stripped because thats as far as it tightened down with the spacer... if i remove the washer I still have atleast 4 perfect threads below that.. does anyone know if there is someway I could make this one work or find an adapter to fix it? I`m sure I can rig an extension to it but do you think that to dangerous?
FYI.. I was extremely cautious about not overtightening it so please dont rub it in... and I`ve wasted too much money on this "hobby" than I should already have...