ashsarna
10-02-2006, 12:43 PM
Hi, I would appreciate any critique of my poishing process. I plan on using the following process (least abraisive to most abraisive) via DA polisher:
Menzerna 106ff (should have a higher cut than FP II but finish better)
OP
Menzerna IP/RMG
OPT compound
I realize I am mixing between Menzerna and OPT. Will I miss any steps doing it this way? Is anything repetitive? I already have the IP, but since being a newbie at DA usage, I prefer the longer work time/less dusting/sun friendly OPT to be in the mix with the Menzerna goodies. Thanks again.
Menzerna 106ff (should have a higher cut than FP II but finish better)
OP
Menzerna IP/RMG
OPT compound
I realize I am mixing between Menzerna and OPT. Will I miss any steps doing it this way? Is anything repetitive? I already have the IP, but since being a newbie at DA usage, I prefer the longer work time/less dusting/sun friendly OPT to be in the mix with the Menzerna goodies. Thanks again.