View Full Version : aio-ksg-p21s
2004WRX
09-25-2006, 11:41 PM
When applying one product after another, is there a certain time i should wait before doing so? i ve read a few threads about waiting 24 hours for certain products. if this is true, do you usually go over it again with a detailing spritz before continuing?(after waiting 24 hrs)
:getdown
Milestones
09-26-2006, 05:52 AM
1. wash car then clay and/or polish if necessary, then put on AIO followed immediately (no waiting time necessary) by a coat of KSG.
then - wait at least 24 hours to allow KSG to cure (I would wait a week to allow KSG to fully cure).
if you don`t drive vehicle at all after step 1 above:
2. put on P21S - you could use a detailing spray to remove any light dust that had accumulated if there was a long time between steps 1 and 2;
or
if you drive vehicle at all after step 1 above:
2. wash car, then put on P21S
Hope that helps......
2004WRX
09-26-2006, 06:15 AM
ok great exactly what i needed to know, and not a moment to late! just about to get started. ill be sure to post some pics.