How will these products work on black?

[Ghost410]

Well I`m back again for some advice, this time on my brothers new Black G35.



I`m trying to figure out what to use. I figure like always, wash the car, clay it out, polish if necessary. But its the next few steps I`m confused about. I plan to glaze, and then either seal, wax or both.



Right now my top glaze is a bottle of VM. But how will this work on black? Will it be good? Or should I really order a bottle of RMG instead.



After which, I was going to hit it with 2 coats of EX-P (24 hours apart of course) and 2 coats of Natty`s Blue (Again spaced out) But I`ve also got some Clearkote Carnauba Moose I can use too, would that be better than Natty`s Blue on this color? Or should I skip the EX-P? Skip the Wax? Whats best for black?



Thanks in advance, I`m just trying to figure out my best bet on this car.

[Scottwax]

I`d go with VM/RMG/Carnauba Moose for the deepest, most liquid look. Natty`s Blue looks really wet on black but it seems a bit bright to me.



Clearkote`s Vanilla Moose using a green Propel pad, hybrid Pink Moose (50/50 mix of Vanilla Moose and Red Machine Glaze) using a Lake Country finishing pad and Carnauba Moose using a Meguiars finishing pad...







http://autopia.org/gallery/data/500/my_626_106_VM_PM_CMW_front1.jpg



http://autopia.org/gallery/data/500/my_626_106_VM_PM_CMW_frontend1.jpg



http://autopia.org/gallery/data/500/my_626_106_VM_PM_CMW_rear1.jpg



http://autopia.org/gallery/data/500/my_626_106_VM_PM_CMW_side1.jpg

[a.k.a. Patrick]

Well I guess that about sums that up now doesnt it??

I think I would skip the RMG and Nattys.......VM, and a couple coats of EX-P or Car MW should be real sweet. I wouldnt dd any Car MW on top of anything though. Chances are with its solvent carriers, it would diminish whats existing...... But if your into the job itself, go ahead and add some RMG to the mix like Scott said.

I dont think you see or feel any difference with the Nattys. Use one or the other........