DSMu4ia
06-14-2006, 07:50 PM
Hey guys..
I just removed some factory badges from a 96 Eclipse.
The problem is that I left a few very slight scratches in the taillight, and you can also still see the outline of where the badges used to be.
It`s annoying and I`m too anal to let it sit. Rather than buy a new center tailight, I was wondering if I could wet sand and then buff?
Does anyone have any experience and could point me to the right product?
I have the usual arsenal of detailing products, but no wetsanding paper.
1500 grit ok to start with?
Or should I go 1000-1500-2000, AIO buff?
Thanks!
Tony
I just removed some factory badges from a 96 Eclipse.
The problem is that I left a few very slight scratches in the taillight, and you can also still see the outline of where the badges used to be.
It`s annoying and I`m too anal to let it sit. Rather than buy a new center tailight, I was wondering if I could wet sand and then buff?
Does anyone have any experience and could point me to the right product?
I have the usual arsenal of detailing products, but no wetsanding paper.
1500 grit ok to start with?
Or should I go 1000-1500-2000, AIO buff?
Thanks!
Tony