Envious Eric
05-23-2006, 03:00 PM
what are some pros and con to these....
http://autogeek.net/orlowpr55inp.html
the way I see it is that they are smaller than the megs pads I currently use, so it will take a TAD bit longer - maybe 5 minutes total IMO, but will provide more cutting action on the way to a 4" pad on a PC. Also, they are smaller so they will take that much less product to load up and will hold less = less wasted product overall.
any comments?
eric
http://autogeek.net/orlowpr55inp.html
the way I see it is that they are smaller than the megs pads I currently use, so it will take a TAD bit longer - maybe 5 minutes total IMO, but will provide more cutting action on the way to a 4" pad on a PC. Also, they are smaller so they will take that much less product to load up and will hold less = less wasted product overall.
any comments?
eric