PDA

View Full Version : cheap wen orbital can polish a little



wibblee
04-16-2006, 12:42 PM
Did a ton of searches and the general consensus was that the cheap random orbitals can`t really do correction/polishing. But since I have an 8" Wen and little disposable income, I picked up some SSR 2.5 and 1, and a few viking microfibre bonnets from Autozone ($6 for 2).



Process:

A line of 2.5 across the bonnet, no pressure at all on the machine (lets the pad spin as fast as possible) and let it run until it began dusting. Wipe off with microfibre.



Swapped bonnets and did the same with SSR 1. There was a thread on whether or not SSR 1 does anything, and I found that by hand or cheap machine, SSR 1 is totally necessary. Quite a bit of hazing otherwise.



Results: (cropped, but otherwise untouched)

http://i58.photobucket.com/albums/g249/wibblee/tsxbef.jpg



after

http://i58.photobucket.com/albums/g249/wibblee/tsxaft.jpg



The outcome is definitely not perfect, but there is marked improvement. This is on Acura paint, but was able to get similar results on the wife`s Oldsmobile. It`s slow going, but easier than elbow grease. Just an option for those of you that might have these and aren`t ready for the PC yet. And as horrible as it sounds, I used the "wooltex" bonnet on the wife`s Oldsmobile and it actually helped speed things up quite a bit.

RTexasF
04-16-2006, 01:05 PM
Interesting. I wouldn`t have thought it stood a chance of working. Thanks, and good work.

imported_mrecktid
04-16-2006, 01:09 PM
How long did it take to break down?

wannafbody
04-16-2006, 03:57 PM
you can get a 4k to11k RO sander at Big Lots for $20. with a polshing or cutting pad it will remove swirls

Black240SX
04-16-2006, 04:04 PM
wibblee: you need to wipe that down with isopropyl alcohol to see if you really removed swirls instead of filling them.

wibblee
04-16-2006, 05:28 PM
I think it took about two minutes for the product to dust on half a panel? My time perception is all out of whack, sorry.



Isn`t the Poorboy`s line free of fillers? From searches, I was under that impression, which is why I chose them.

blingbling
04-17-2006, 05:17 AM
I get decent results using a Wen Orbital too. The scuffs took 4 passes of MPPC to clear, the rest of the body only needed a once over.



http://img388.imageshack.us/img388/4107/temp11ht.jpg



Since I live in an apartment I use the Wen running off a jump-start battery pack and power inverter. Very handy to clean paint and apply sealants thin.



I don`t seem to be able to break down most polishes with it though. I do defect removal at my parent`s with a "grown-up" RO :waxing: